Bio-rad BioLogic QuadTec™ Detector and Components Bedienungsanleitung PDF herunterladen (Seite 23)

3.1 ELECTRICAL CONNECTIONS TO THE BIOLOGIC HR SYSTEM

Set up the BioLogic HR system with the QuadTec detector on the bottom tray. Do not turn power on.

1. Connect one SIM-HR to the HR Workstation with System Cable 17, and ensure that the SIM’s

device address number (Device Number) is set to 1.

2. "Daisy-chain" a second SIM-HR to the first SIM-HR using a second System Cable 17. The device

address number (Device Number) of this second SIM-HR must be set to 0.

3. Connect the QuadTec to the SIM-HR modules using two System Cable 24, an analog cable that has

red and black bare wires at one end and a gold colored banana plug at the other. Plug the banana

plugs into the 1V Integrator sockets on the rear of the QuadTec marked 1 and 2. The cable in socket

1 should go to the first SIM-HR (Device Number 1) and the cable in socket 2 goes to the second

SIM-HR (Device Number 0). In both cases the cable red wire goes to the analog + connector and

the black wire to the analog - connector of the SIM-HR.

4. If a Model 2128 Fraction Collector is to be used, connect it to SIM 2 using System Cable 17.

Figure 3-2. Connections to the BioLogic HR System

USE WITH THE BIOLOGIC HR SYSTEM SYSTEM INSTALLATION AND SETUP

3-2

WORKSTATION

MODEL 2128

FRACTION

COLLECTOR

SIM 2 (ADDRESS 0)

SIM 1 (ADDRESS 1)

MODEL 1327

CHART RECORDER

SYSTEM CABLE 17

SYSTEM

CABLE 17

SYSTEM CABLE 24

SYSTEM

CABLE 2

AV7-3

AUTOMATED

INJECT VALVE

CONDUCTIVITY

MONITOR

SYSTEM

CABLE 17

SYSTEM

CABLE 4

QUADTEC

DETECTOR

COLOR MONITOR

SYSTEM CABLE 17

CONTROLLER

KEYBOARD

MOUSE

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare

Bio-rad BioLogic QuadTec™ Detector and Components Bedienungsanleitung Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Bio-rad BioLogic QuadTec™ Detector and Components