Bio-rad Model EM-1 Econo™ UV Monitor Bedienungsanleitung PDF herunterladen (Seite 17)

Appendix A

Flow Cell Replacement

1. Remove the retaining clip from the bottom of the optics module and

pull the luer connectors away from their holders as shown in Figure

A-1.

2. Unscrew thumbscrew and remove the old flow cell.

3. Reinsert the new flow cell following the above steps in reverse

order. (Do not over-tighten the thumb screw.)

Warning: To avoid exposure to UV radiation, make sure that the

UV lamp is off when changing filters and flow cells.

Fig. A-1. Flow cell replacement.

Retaining Clip

Thumbscrew

Flow Cell

Luer Connectors

M7318160G.qxd 05/08/2003 2:05 PM Page 14

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Keine Kommentare

Bio-rad Model EM-1 Econo™ UV Monitor Bedienungsanleitung Seite 17